TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 574 of 734

TM 5-5420-202-34

FUEL TANK (RIGHT) REPLACEMENT (Sheet 7 of 15)

23.

Continue moving fuel tank to rear until

front section is clear of crew compartment

floor.

24.

Using four persons, remove fuel tank

from vehicle.

When draining or filling fuel tank,

post notice

that smoking is not

allowed in or near vehicle.

Fuel is

flammable.

NOTE

A small amount of fuel

in the fuel tank.

container

by tilting

Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal

injury, wear protective goggles and gloves and use only in a well-ventilated

area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors.

Do not use near open flame or excessive heat. The flash point for Type #1

Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C). If you

become dizzy while using cleaning solvent, get fresh air immediately and get

medical aid. If contact with eyes is made, wash your eyes with water and get

medical aid immediately.

may still be

Drain into

fuel tank

25.

Use putty knife and dry cleaning solvent

to remove seals (AM) from hull. Clean

area of all adhesive and mask area on hull

where seals had been.

NOTE

If fuel tank is to be repaired, go to

page 7-331.

If fuel tank is to be

replaced, go to step 26.

Go on to Sheet 8

4-15

Change 5

7-339

TM 5-5420-202-20-2