TM-5-5420-202-20-2

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 2 OF 4

OCTOBER 1985

TM-5-5420-202-20-2 - Page 625 of 734

9.

Go into vehicle and, using 9/16 inch wrench to hold screws (N) and 9/16 inch socket and

FUEL TANKS (LEFT AND RIGHT) UPPER FRONT MOUNT REPLACEMENT

(Sheet 3 of 6)

ratchet to loosen nuts (P), remove three nuts (P), lockwashers (Q), and screws (N) securing

plate (R) at corner bulkhead opening.

10.

Remove mounting plate (R).

1.

Clean rubber mounts with detergent and warm water.

Dry cleaning solvent P-D-680 is toxic and flammable. To prevent personal

injury, wear protective goggles and gloves and use only in a well-ventilated

area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors.

Do not use near open flame or excessive heat. The flash point for Type #1

Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C). If you

become dizzy while using cleaning solvent, get fresh air immediately and get

medical aid. If contact with eyes is made, wash your eyes with water and get

medical aid immediately.

2.

Clean metal parts with dry cleaning solvent. Using rag, wipe parts dry.

3.

Inspect mounts for cuts or wear.

4.

Inspect metal parts for damage, wear, or stripped threads. Repair as required.

4-68

7-390

Change 5

TM 5-5420-202-20-2

CLEANING AND INSPECTION: