TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 1042 of 1060
TM 5-5420-202-20-3
FRONT FENDER (CENTER LEFT AND RIGHT) STOWAGE BOX COVER REPAIR (Sheet 4 of 4)
5.
6.
12.
Place lock (E) in position on stowage cover (B).
Using blacksmith’s anvil and hammer, install
six new rivets (F).
Close cover (B) and check for positive
7.
8.
9.
10.
latching of handle (G). Add shim washers (Q)
as necessary to assure positive latching.
Using 11/16 inch wrench, tighten nut (K)
until hole in handle (G) alines with groove in
nut.
Using pliers, install new cotter pin (R).
Using pliers, install S-hook (S).
Install stowage box on vehicle (page 16-77).
End of Task
Place handle (G) in position on lock (E).
Place tongue (H), washer (J), and nut (K) on
handle (G).
Place stowage box cover (B) in position on
stowage box.
Using 9/16 inch wrench, install twelve
screws (L) and lockwashers (M) securing
four hinges (N) and six tapping plates (P)
to cover (B).
TA249756
16-83
Back to Top
