TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

  TM-5-5420-202-20-3 - Page 437 of 1060

FRONT ACCESSORY HARNESS REPLACEMENT (Sheet 11 of 14)
20.
Route wiring harness assembly (A) along right side of hull to clip bracket assembly (AH)
below right headlight.
NOTE
When installing harness,
make sure circuit numbers
of all electrical leads match
with mating leads.
21.
22.
23.
24.
Connect five connectors (AJ), CKT
17, 18, 20, 514, and 515 to connectors
(AK). Press connectors into clips of
bracket (AH).
Connect connector (AJ) CKT 19 to dummy load in bracket (AH).
Using 7/16 inch socket, install three straps (AL), flat washers (AM), new lockwashers
(AN), and screws (AP) securing wiring harness assembly (A).
Using 5/8 inch wrench, install electrical lead (AQ) and nut (AR) to terminal of center
battery.
Go on to Sheet 12
10-296.98
Change 7
TM 5-5420-202-20-3


Back to Top