TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 648 of 1060

TM 5-5420-202-20-3

BRAKE MASTER CYLINDER REPLACEMENT (Sheet 6 of 9)

INSTALLATION:

1.

Using 1-1/8 inch socket, remove filler

cap (A) from master cylinder (B).

CAUTION

Look inside the master cylinder (B)

through the filler cap hole (C) to the

bottom. The hole arrangement must

look like the pattern of holes shown

in (D).

If not, install filler cap (A),

get the correct one, then repeat step 1

above.

2. Get master cylinder ready for installation by removing all packing material, pipe plugs,

or plastic caps from ports (E) if installed. Clean as needed.

3.

Using fingers, install filler cap (A) to master

4.

Using 3/4 inch wrench, remove drain plug (F)

at forward port (H).

cylinder (B) finger tight.

and gasket (G) and relocate and install

Go on to Sheet 7

TA249397

13-7