TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 152 of 534

TM 5-5420-202-20-4

TACHOMETER REAR FLEXIBLE SHAFT REPLACEMENT (Sheet 4 of 6)

CLEANING AND INSPECTION:

WARNING

Dry

C

leaning solvent P-D-680 is toxic and flammable.

To prevent personal injury, wear

protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,

eyes and clothes and don't breathe

V

apors. Do not use near open flame or excessive heat. The

flash point for Type #1 Dry Cleaning Solvent is 100° (38°C) and for Type #2 is 138°F (50°C).

If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.

If contact with eyes is made, wash your eyes with water and get medical aid immediately.

1.

Using dry cleaning solvent and rags, clean

all component parts.

2.

Inspect all component parts for damage

or wear, replace as required.

ASSEMBLY:

1.

2.

3.

4.

5.

Install flat washer (A) into tachometer adapter end (B).

Install core (C) through adapter end (B).

Using slip joint pliers, pull core (C) approximately 2 inches from tachometer drive end (D).

Install slotted washer (E) and gasket (F).

Push core (C) back into flexible shaft (G) until seated.

NOTE

If replacing or installing plastic tubing on flexible shaft (G),

do steps 6 thru 9 below. If not, go directly to installation.

Go on to Sheet 5

TA248653

19-28