TM-5-5420-202-20-4

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4

OCTOBER 1985

TM-5-5420-202-20-4 - Page 153 of 534

TACHOMETER REAR

6.

Using steel rule,

(B).

TM 5-5420-202-20-4

FLEXIBLE SHAFT REPLACEMENT (Sheet 5 of 6)

measure back approximately 10 inches from tachometer adapter end

7.

From 10 inch mark, wrap shaft (G) with tape 5 inches to the rear

mately 5/8 inch in diameter.

until shaft (G) is approxi-

8.

Place heat shrink plastic tubing (H) over tape.

NOTE

Avoid overheating in one spot as plastic tubing melts easily.

9.

Using heat gun, shrink tubing by moving hot air back and forth over entire length of

tubing.

INSTALLATION:

1.

Person in powerplant compartment, attach

wire to powerplant end of shaft (A).

2.

Person in crew compartment, pull on wire

to thread shaft (A) back into position.

3.

Remove wire from shaft (A).

Go on to Sheet 6

TA248654

19-29