TM-5-5420-202-20-4
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 4 OF 4
OCTOBER 1985
TM-5-5420-202-20-4 - Page 66 of 534
page 5-2
TM 5-5420-202-20-4
REAR DRAIN VALVE LINKAGE ADJUSTMENT (Sheet 1 of 7)
TOOLS: 9/16 in. combination box and open end wrench (2 required)
Slip joint pliers
1/8 in. dia. alinement pin (2 in. long)
6 in. steel rule
SUPPLIES:
Cotter pins (2 required)
REFERENCE:
TM 5-5420-202-10
1.
Using pliers, remove cotter pin (A) from clevis pin (B).
2.
Pull clevis pin (B) out of holes in clevis (C).
3.
Put alinement pin (D) through hole in bracket (E) and hole in lever (F).
4.
Using 9/16 inch wrench, loosen jamnut (G) all the way while holding clevis (C) with pliers.
Go on to Sheet 2
TA248571
17-40
Back to Top
