TM-5-5420-203-14

BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE

JUNE 1991

TM-5-5420-203-14 - Page 219 of 298

TM 5-5420-203-14

RAMP SECTION DECK EXTRUSION REPLACEMENT (Sheet 2 of 4)

e.

f.

g.

h.

i.

j.

NOTE

Flat washer (item 11) serves as a spacer between the varying width deck extrusions. Refer

to TM 5-5420-203-24P, Repair Parts and Special Tools List (RPSTL) for identification of

the replacement flat washer (spacer) needed. Alteration of the flat washer (shaving,

sanding, and cutting) to fit is not authorized.

Slide screw (10) back until it releases

flat washer (spacer )(1 1).

Remove flat washer (13) and screw (10)

from deck extrusions (5 and 12).

NOTE

Steps g. and h. are for removal of the

lifting bar (14).

Remove two nuts (15) and two lock

washers (16) securing lifting bar (14) in

position. Discard lock washers.

Remove lifting bar (14) and two screws (17).

NOTE

Removal of male electrical retainers

requires the removal of attached deck

extrusions. The number of mounting

screws varies.

Refer to the alphabetical lettering on the

illustration and remove four deck extrusions

marked A, B, and C in accordance with

steps a. thru h. above.

Remove four deck extrusions with male

electrical retainer (18) attached as a unit.

3-53