TM-5-5420-203-14

BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE

JUNE 1991

TM-5-5420-203-14 - Page 228 of 298

TM 5-5420-203-14

NEAR-SHORE CENTER SECTION REPLACEMENT

m. Using lifting device and sling, position

damaged center section (4) aside.

INSTALLATION

INSTALL NEAR-SHORE CENTER SECTION (4 AND 7).

a.

b.

c.

d.

e.

f.

g.

h.

Using lifting device and sling, place the

replacement center section (4) about 1 ft from

and in line with center section (7) to be joined.

Route flexible hydraulic line (16) located on

center section (7) through hose guide (17)

located on replacement center section (4).

Connect end of flexible hydraulic line (16) to

center section (4). Ensure connection is secure.

Using lifting device and sling, position

replacement section (4) so connecting points

(15 and 18) mate with other center section (7).

Ensure flexible hydraulic line previously

connected is not pinched.

NOTE

Some side to side and up and down

adjustment may be required to install

connecting pins.

Install quadrant hinge pin (6) through

lower center hinge point (19) of center

sections (4 and 7).

Install center section pin (12) through lower

center section hinge point (18). Install pin

retainer (11) through pin (12).

Install connector pin (14) through upper center

section hinge connecting point (15). Install pin

retainer (13) in pin (14).

Install connector pin (9) through center section

connecting point (10). Install pin retainer (8) in

pin (9).

(Sheet 3 of 4)

3-62