TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 398 of 750

TM 5-5420-228-24

FILTER-TO-PUMP HOSE ASSEMBLY (CZ) REPLACEMENT (Sheet 2 of 3)

3.

4.

5.

6.

7.

Use adjustable wrench to remove hose

assembly “CZ” (A) from elbow (E).

Using adjustable wrench, remove elbow

(E) and collar (F) from elbow (G).

Holding bushing (H) with adjustable wrench,

use pipe wrench to remove elbow (G)

from bushing (H).

Using adjustable wrench, remove bushing

(H).

NOTE

Nipple (J) may come out with bushing (H).

If it does, nipple (J) may be used again.

Using pipe wrench, remove nipple (J)

from pump (K) and throw nipple (J)

away.

INSTALLATION:

NOTE

. Before installation, use pipe tape on all male

threads. Start tape on second thread so tape will

not enter hydraulic system.

. If nipple (A) was not thrown out during removal,

1.

2.

3.

4.

5.

start this procedure at step 2.

Manually install new nipple (A) in

bushing (B).

Using adjustable wrench, install bushing

(B) and nipple (A) in pump (C).

Using adjustable wrench to hold bushing

(B), use pipe wrench to install elbow

(D) on bushing (B).

Using adjustable wrench, install

(E) and collar (F) on elbow (D).

Using adjustable wrench, install

assembly “CZ” (G) on elbow (E).

Go on to Sheet 3

elbow

hose

TA251595

3-201