TM-9-1240-401-34-P
TELESCOPE MOUNT M146: M118A2 AND M118A3; TELESCOPE MOUNT M145: M145A1; PANORAMIC TELESCOPE: M117 AND M117A2; FIRE CONTROL QUADRANT: M15; PERISCOPE: M42
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1993
TM-9-1240-401-34-P - Page 353 of 590
D-3
TM 9-1240-401-34&P
Code
MO- (Made at unit/
AVUM Level)
MF- (Made at DS/
AVUM Level)
MH- (Made at GS
Level)
ML- (Made at Spe-
cialized Repair
Activity (SRA))
MD- (Made at Depot).
AF-
AH-(Assembled by
AL-
AD-
AO-(Assembled by
unit/AVUM
Level)
(Assembled by
DS/AVIM Level)
GS Category)
(Assembled by
SRA)
(Assembled by
Depot)
Explanation
Items with these codes are not to be requested/
requisitioned individually. They must be made
from bulk material which is identified by the part
number in the DESCRIPTION AND USABLE
ON CODE (UOC) column and listed in the bulk
material group of the repair parts list in this
RPSTL. If the item is authorized to you by the 3d
position code of the SMR code, but the source
code indicates it is made at a higher level, order
the item from the higher level of maintenance.
Items with these codes are not to be requested
requisitioned individuality. The parts that make
up the assembled item must be requisitioned or
fabricated and assembled at the level of mainte-
nance indicated by the source code. If the 3d
position code of the SMR code authorizes you to
replace the item, but the source code indicates
the item is assembled at a higher level, order the
item from the higher level of maintenance.
NOTE
Cannibalization or controlled exchange, when authorized, maybe used as a source of supply for items with
the source codes, listed below, except for those source-coded "XA" or those aircraft support items restricted
by requirements of AR 700-42.
XA – Do not requisition an "XA"-coded item. Order its next higher assembly.
XB – If an "XB" item is not available from salvage, order it using the CAGEC and part number given.
XC – Installation drawing, diagram, instruction sheet, field service drawing that is identified by manufacturer’s part
number.
XD - Item is not stocked. Order an “XD”-coded item through normal supply channels using the CAGEC and part
number given, if no NSN is available.
(2) Maintenance Code. Maintenance codes tell you the level(s) of maintenance authorized to USE and RE-
PAIR support items. The maintenance codes are entered in the third and fourth positions of the SMR code as follows:
(a) The maintenance code entered in the third position tells you the lowest maintenance level authorized
to remove, replace, and use an item. The maintenance code entered in the third position will indicate authorization to
one of the following levels of maintenance.
Back to Top
