TM-9-2320-209-10-4
2 1/2-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; OPERATOR LEVEL
SEPTEMBER 1980
TM-9-2320-209-10-4 - Page 34 of 87
TM 9-2320-209-10-4
2-7. FRONT AND OUTER REAR WHEELS REMOVAL AND REPLACEMENT.
NOTE
The following tasks are the same for both front wheels
and all four outer rear wheels.
TOOLS : Wheel stud nut wrench and handle
Hydraulic screw jack with handle
SUPPLIES: None
PERSONNEL: One
EQUIPMENT CONDITION:
Truck parked on level ground, engine off, handbrake
set, wheels chocked.
a. Preliminary Procedure. Remove spare wheel if needed to replace damaged
wheel. Refer to para 2-6.
b. Removal.
FRAME 1
I
1.
Using wheel stud nut wrench (1), loosen six wheel stud nuts (2). Do not take
off wheel stud nuts.
NOTE
Wheel stud nuts (2) on left side have left hand threads
and must be turned to the right to loosen them. Wheel stud
nuts on right side have right hand threads and must be
turned to the left to loosen them. Studs and nuts are
stamped (L) left and (R) right.
GO TO FRAME 2
2-22
Back to Top
