TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 109 of 830

TM 9-2320-209-20-3-1

(e) Tee fitting

CAUTION

Fittings are made of soft brass. They can be stripped

very easily if overtightened. Tighten fittings only

enough to stop fuel 1 caking.

NOTE

Tee fitting at the secondary and final filter assemblies

on trucks with LD-465 engine is used for this typical

procedure.

FRAME 1

I

1.

Using 10-inch pipe wrench, screw in and tighten tee fitting (1).

2.

Using 9/16-inch wrench, screw in and tighten elbow (2).

3.

Using 11/ 16-inch combination box and open end box wrench, screw on and tighten

hose nut (3).

4.

Using 9/16-inch wrench, screw in and tighten elbow (4). Using 5/8-inch combina-

tion box and open end box wrench, screw on and tighten tube nut (5).

NOTE

Follow-on Maintenance Action Required:

1.

Start engine.

Refer to TM 9-2320-209-10.

2.

Check that fuel lines and fittings have no leaks.

3.

Close hood and left side panel. Refer to

TM 9-2320-209-10.

4.

Stop engine.

Refer to TM 9-2320-209-10.

END OF TASK

4-27