TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 619 of 830

TM 9-2320-209-20-3-1

7-49. OIL PRESSURE TRANSMITTER REMOVAL AND REPLACEMENT.

TOOLS:

3/4-inch open end wrench (2)

SUPPLIES:

Heat resistant sealer, type II, MIL-S-45180

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

Preliminary Procedure. Remove air cleaner filter element. Refer to

TM 9-2320-209-10.

CAUTION

Make sure ACCESSORY switch is set to OFF

position while doing this procedure. Failure

to do this may cause a short and damage

wiring or transmitter.

b.

Removal.

1.

Take connector (1) off oil pressure transmitter (2).

2.

Using 3/4-inch wrench, unscrew oil pressure transmitter (2) from adapter

fitting (3).

Hold adapter fitting from turning in elbow (4) with 3/4-inch

wrench.

END OF TASK

7-183