TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

  TM-9-2320-209-20-3-1 - Page 775 of 830

TM 9-2320-209-20-3-1
1.
Place one side of yoke (1) on wood block as shown.
NOTE
Diameter of drift pin punch should be just a little
smaller than diameter of bearing.
2.
Center drift pin punch (2) on face of top bearing (3) as shown. Tape drift
pin punch lightly with hammer until bottom bearing (4) is driven out.
3.
Turn yoke (1) over and repeat steps 1 and 2 to drive out other bearing.
4.
Tilt spider (5) to one side and lift spider out of yoke (1).
GO TO FRAME 3
10-13


Back to Top