TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 783 of 830

e.

Assembly (Snapring and C-Ring Type).

NOTE

This procedure is the same for both

TM 9-2320-209-20-3-1

types except where noted.

1.

Put four retainers (1) and four gaskets (2) on journals (3).

2.

Screw grease fitting (4) into spider (5) and tighten using 5/16-inch wrench.

3.

Put spider (5) into flange yoke (6) by tilting spider as necessary.

4.

Using fingers, press two bearings (7) over two journals (3) through holes

in yoke (6).

5.

Place assembly on a wood block as shown.

Hold spider (5) in place and tap

each bearing (7) into yoke (6) using rawhide mallet.

GO TO FRAME 2

10-21