TM-9-2320-209-20-3-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4

MAY 1981

TM-9-2320-209-20-3-2 - Page 172 of 552

TM 9-2320-209-20-3- 2

(b) Air tube junction tee fitting assembl y

CAUTIO N

Fittings are made of soft brass. They can b e

stripped if tightened too much. Tighten fitting s

just enough to stop air from leaking .

NOT E

The air tube junction tee fitting assembly on th e

air compressor governor is used for this typica l

procedure .

1 .

Using adjustable wrench, carefully screw in and tighten tee fitting (1) .

2 .

Using 5/8-inch combinatio n

tighten two tube nuts (2) .

Follow-o n

box and open end box wrench, screw on an d

NOT E

Maintenance Action Required :

1 .

Start engine and let it run until air pressure gag e

reads between 65 and 125 psi. Refer t o

TM 9-2320-209-10 .

2 .

Stop engine .

Refer to TM 9-2320-209-10 .

3 .

Do air system leak test .

Refer to Part 1, para 1-5 .

END OF TAS K

13-15 9