TM-9-2320-209-20-3-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4

MAY 1981

  TM-9-2320-209-20-3-2 - Page 299 of 552

TM 9-2320-209-20-3- 2
1 .
Using 1-inch wrench, hold adapter (1). Using 1 1/16-inch wrench, scre w
coupling nut (2) .
Take away and save adapter .
2 .
Slide coupling nut (2) with spring (3) back on hose (4) so sleeve (5) can b e
seen .
Sleeve must be tight on hose and hose must be out past sleeve .
3 .
Go to other end of hose and do frames 1, 2, and 3 again. Do steps 1 and 2
of this frame again. Then go to step 4 .
WARNIN G
Eye shields must be worn when using compressed air .
Eye injury can occur if eye shields are not used .
4 .
Using compressed air , blow through hose (4) to clean out any chips or dirt .
NOT E
Follow-on Maintenance Action Required :
Replace adapter and hose in truck. Refer to para 13-41 .
END OF TAS K
13-28 6


Back to Top