TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 80 of 552
TM 9-2320-209-20-3- 2
FRAME 5
1 .
Turn brake drum (1) until inspection hole (2) is at bottom of left brak e
lining .
2 .
Put 0.010-inch feeler gage in inspection hole (2) so it is between brak e
lining (3) and inside of brake drum (4) and can be pulled out with drag .
3 .
If feeler gage just goes in easily, take feeler gage away and go to frame 6 .
If it does not, go to step 4 .
4 .
Using 1 1/8-inch box wrench, loosen and hold jamnut (5). Using 1/2-inc h
open end wrench, turn anchor pin (6) to right until feeler gage jus t
in easily and can be pulled out with drag .
5 .
Using 1/2-inch open end wrench, hold anchor pin (6). Using 1 1/8 -
wrench, tighten jamnut (5) .
GO TO FRAME 6
goe s
inch bo x
13-6 7
Back to Top
