TM-9-2320-209-34-2-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 3

MAY 1981

TM-9-2320-209-34-2-1 - Page 348 of 770

TM 9-2320-209-34-2-1

7-10. FLOODLIGHT HARNESS REMOVAL AND REPLACEMENT (TRUCK M756A2).

NOTE

Refer to removal and replacement procedures given

in TM 9-2320-209-20, if needed, to work on con–

nectors and electrical leads covered in this task.

TOOLS : No special tools required

SUPPLIES: 8 gauge wire, 6 feet

PERSONNEL: One

EQUIPMENT CONDITION :

Truck parked, engine off, handbrake set.

a. Preliminary Procedure. Remove cab protector. Refer to TM 9-2320-209-20.

b. Removal.

NOTE

Tag all leads so that they are put back in the right place.

1. Unplug four connectors (1) from left and right floodlights.

2. Unplug three connectors (2) from clearance lights.

3. Take off four grommets (3).

4. Put four connectors (1) through two holes and into cab protector.

5. Put three connectors (2) through hole and into cab protector.

6. Put three connectors (4) through hole and into cab protector.

7. Hook floodlight harness and pull it out through top right end of cab

protector.

END OF TASK

7-33