TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 198 of 592

TM 9-2320-209-34-2-3

FRAME 2

1.

Replace hydraulic hoist control linkage. Refer to

TM 9-2320-209-20.

2. Slide two roller arm assemblies (1) onto crosshead (2).

Soldier A 3.

Start engine and raise dump body to raise crosshead (2) with

roller arm assemblies (1) .

Refer to TM 9-2320-209-10.

Soldier B 4.

Align holes in roller arm assemblies (1) with holes in dump

body (3).

NOTE

A jack may be needed to finish aligning holes.

5.

Drive pin (4) through dump body (3) and roller arm assemblies

(1). Align screw holes in pins with screw holes in dump body.

GO TO FRAME 3

18-187