TM-9-2320-209-34-2-3
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3
MAY 1981
TM-9-2320-209-34-2-3 - Page 26 of 592
TM 9-2320-209-34-2-3
c.
Cleaning. There are no special cleaning procedures needed. Refer to clean-
ing procedures given in Part 1, para 1-3.
d.
Inspection and Repair.
FRAME 1
1.
2.
3.
4.
NOTE
Readings must be within limits given in table 18-1. If
readings are not within given limits, throw away part
and get a new one.
Check that drum shaft (1) has no nicks or burrs. Take off nicks and burrs
with a honing stone. If more repair is needed, throw shaft away.
Measure outer diameter of drum shaft (1).
Measure inside diameter of two drum bushing type bearings (2).
Check that teeth of drum shaft gear (3) are not broken, chipped or scored.
If gear is damaged, get a new one.
GO TO FRAME 2
Table 18-1. Front Winch (Drum Shaft and Bearing) Wear Limits
Size and Fit
Index
of New Parts
Wear Limit
Number
Item/Point of Measurement (inches) (inches)
1
Drum shaft outer diameter
1.8730 to 1.8750 1.8710
2
Drum bushing type bearing
inside diameter 1.8770 to 1.8800 1.8950
18-15
Back to Top
