TM-9-2320-209-34-2-3
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3
MAY 1981
TM-9-2320-209-34-2-3 - Page 294 of 592
TM 9-2320-209-34-2-3
CHAPTER 19
BUMPER AND GUARDS GROUP MAINTENANCE
Section I. SCOPE
19-1. EQUIPMENT ITEMS COVERED.
This chapter gives equipment maintenance pro-
cedures for the bumper, brackets, guards, and protective devices for which there are
authorized corrective maintenance tasks at the direct and general support maintenance
levels.
19-2. EQUIPMENT ITEMS NOT COVERED.
All equipment items for which corrective
maintenance is authorized at the direct and general support maintenance levels are
covered in this chapter.
Section II.
BUMPER, BRACKETS, GUARDS, AND
PROTECTIVE DEVICES
19-3. FRONT BUMPER REINFORCING
MENT (ALL TRUCKS WITHOUT
TOOLS:
No special tools required
GUSSETS REMOVAL, REPAIR, AND REPLACE-
FRONT WINCH).
SUPPLIES:
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Rags
PERSONNEL: Two
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a.
Preliminary Procedures.
(1) Remove brush guard. Refer to para 19-5.
(2) Remove two lifting shackles and lifting shackle brackets. Refer to
TM 9-2320-209-20.
19-1
Back to Top
