TM-9-2320-209-34P
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
DIRECT AND GENERAL SUPPORT MAINTENANCE; REPAIR PARTS AND SPECIAL TOOLS LISTS (INCLUDING DEPOT MAINTENANCE REPAIR PARTS)
NOVEMBER 1989
CHANGE 2
TM-9-2320-209-34P - Page 16 of 908
TM 9-2320-209-34P
TM 9-2920-243-34
TM 9-2990-201-45
TM 9-2520-246-34
TM 9-2520-246-34P
TM 9-2520-246-34P
TM 9-8023-6
TM 9-8617
TM 9-8637
DS and GS Maintenance Manual
(Including Repair Parts and
Special Tools List): Starter,
Engine, Electrical, Leece-Neville
Model
GS and Depot Maintenance
Manual, Turbocharged Engine
(Including Repair Parts and
Special Tool Lists)
DS, GS and Depot Maintenance
Manual for Transmissions,
Transfers and Power Takeoffs
DS and GS Maintenance Repair
Parts and Special Tool Lists for
Transmissions, Transfers and
Power Takeoffs
DS and GS Maintenance Repair
Parts List (Including Depot
Maintenance Allowances): Winch
Assembly and with Cable Level
Winch Assembly
Ordnance Maintenance
Winches, Power Takeoffs, Power
Divider and Hydraulic Equip-
ment
Electrical Equipment
5. How to Locate Repair Parts.
a.
When National Stock Number or Part
Number is Unknown:
(1) First.
Using the table of contents,
determine the functional group within which the repair
part belongs. This is necessary since illustrations are
prepared for functional groups, and listings are divided
into the same groups,
(2) Second.
Find the illustration covering
the functional group to which the repair part belongs.
(3) Third.
Identify the repair part on the
illustration and note the illustration figure and item
number of the repair part.
(4) Fourth.
Using the Repair Parts
Listing, find the figure and item number noted on the
illustration.
b.
When National Stock Number or Part
Number is Known.
(1). First.
Using the Index of National
Stock Numbers and Part Numbers, find the pertinent
National stock number or part number. This index is in
ascending NSN sequence followed by a list of part
numbers in ascending alphanumeric sequence, cross-
-referenced to the illustration figure number and item
number.
(2) Second.
After finding the figure and
item number, locate the figure and item number in the
repair parts list.
6.
Abbreviations.
Abbreviation
AWG
br
cd
id
in.
NI
No.
od
s
syn-ru
thd
thk
w
W/
W/O
zn
zn-pltd
7.
Recommendation
Improvements,
Explanation
American wire gage
brass
cadmium
inside diameter
inch
not illustrated
number
outside diameter
steel
synthetic rubber
thread
thick
wide
with
without
zinc
zinc plated
for Maintenance Publications
You can help improve this manual by calling
attention to errors and by recommending improvements
and stating your reasons for the recommendations. Your
letter or DA Form 2028, Recommended Changes to
Publications, should be mailed directly to Commander,
U.S. Army Tank-Automotive Materiel Readiness
Command, ATTN: DRSTA-MB, Warren, Michigan
48090. A reply will be furnished directly to you,
x
Change 1
Back to Top
