TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 1041 of 1337
TM 9-2320-260-20
13-27. DUMP CONTROLS REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
M817
TM 9-2320-260-10
MATERIALS/PARTS
Cotter pin
Woodruff key
Six locknuts
TM 9-2320-260-20P
EQUIPMENT CONDITION
•
Parking brake set (TM 9-2320-260-10).
• Driver’s seat removed (para. 11-32).
1. Remove cotter pin (11), clevis pin (9), and control rod (10) from
2. Bend four tabs (20) and remove boot (12) from floor (8).
NOTE
Assistant will help with step 3.
lever (15). Discard cotter pin (11),
3. Remove four locknuts (13), screws (14), and two brackets (7) from floor (8). Discard locknuts (13).
4. Remove locknut (17), screw (16), lever (15), and woodruff key (18) from shaft (l). Discard
locknut (17) and woodruff key (18).
5. Remove two brackets (7) from shaft (1).
6. Remove locknut (6), washer (5), spring (4), and lock (2) from lever (3). Discard locknut (6).
7. Remove two grease fittings (19) from brackets (7).
1.
2.
3.
4.
5.
6.
7.
8.
Install two grease fittings (19) on brackets (7).
Install lock (2) on lever (3) with spring (4), washer (5), and new locknut (6).
Position two brackets (7) on shaft (1).
Install new woodruff key (18) on shaft (1).
Install lever (15) on shaft (1) with screw ( 16) and new locknut (17).
NOTE
Assistant will help with step 6.
Install two brackets (7) on floor (8) with four screws (14) and new locknuts (13).
Install boot (12) through opening in floor (8) and bend tabs (20) to secure in place.
Install control rod (10) on lever (15) with clevis pin (9) and new cotter pin (11).
13-68
Back to Top
