TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 1069 of 1337

TM 9-2320-260-20

13-42. HOIST WINCH CABLE REPLACEMENT (M816, M819)

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

M816, M819

TM 9-2320-260-10

MATERIALS/PARTS

Four lockwashers

TM 9-2320-260-20P

EQUIPMENT CONDITION

Two locknuts

●

Parking brake set (TM 9-2320-260-10).

PERSONNEL REQUIRED

●

Wrecker hoist winch block removed (para. 13-39).

Two

GENERAL SAFETY INSTRUCTIONS

Wear hand protection when handling winch cable.

WARNIN G

Wear hand protection when handling winch cable. Broken wires

may cause injury to personnel.

NOT E

Maintain manual tension on hoist cable.

1. Remove four screws (7), lockwashers (6), washers (5), and guard (4) from rear sheaves (8). Discard

lockwashers (6).

2. Remove two locknuts (2), screws (11), and spacers (1) from inner boom (10). Discard locknuts (2).

3. Remove setscrew (12) and cable (9) from hoist winch drum (13).

4. Firmly grasp cable (9) and remove cable (9) from boom (3),

1. Guide and position cable (9) on boom (3) and rear sheaves (8).

2. Install cable (9) on hoist winch drum (13) with setscrew (12).

3. Install two spacers (1) on inner boom (10) with two screws (11) and new locknuts (2).

4. Install guard (4) on boom (3) with four washers (5), new lockwashers (6), and screws (7).

13-96