TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 511 of 1337
TM 9-2320-260-20
I
4-39. WARNING SIGNAL LAMP, HOUSING, AND BRACKET REPLACEMENT
THIS TASK COVERS:
a. Signal Lamp Removal
c. Signal Light Housing Installation
b. Signal Light Housing Removal
d. Signal Lamp Installation
INITIAL SETUP
APPLICABLE MODELS
EQUIPMENT CONDITION
M816, M819
•
Parking brake set (TM 9-2320-260-10).
MATERIALS/PARTS
• Battery ground cable disconnected (para. 4-48).
Four locknuts
GENERAL SAFETY INSTRUCTIONS
Lockwasher
Eye protection must, be worn when removing or
REFERENCES (TM)
installing springs under tension.
TM 9-2320-260-10
TM 9-2320-260-20P
I
a. Signal Lamp Removal
1. Remove three screws (17) and retaining ring (1) from lamp housing (6).
2.
Disconnect wires (4) and (5) from lamp housing (6).
Eye protection must be worn when removing or installing springs
under tension. Failure to do so may result in injury
3.
Remove three springs (3) and lamp (2) from retaining ring (1).
to personnel.
b. Signal Light Housing Removal
1. Disconnect wire (7) from lamp housing (6).
2. Remove nut (14), lockwasher (15), mounting washer (16), and lamp housing (6) from bracket (12).
Discard lockwasher (15).
3. Remove four locknuts (9), screws (13), bracket (12), and protector box (10) from fender (11). Discard
locknuts (9).
4. Remove grommet (8) and wire (7) from fender (11).
c.
Signal Light Housing Installation
1. Insert wire (7) through hole in fender (11).
2. Place grommet (8) around wire (7) and install on fender (11).
3. Position bracket (12) and protector box (10) on fender (11) and install with four screws (13) and
new locknuts (9).
4. Install lamp housing (6) on bracket (12) with mounting washer (16), new lockwasher (15), and
nut (14).
5. Connect wire (7) to lamp housing (6).
4-70
Back to Top
