TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 515 of 1337
TM 9-2320-260-20
I
4-41. BLACKOUT DRIVE LAMP AND HOUSING REPLACEMENT
THIS TASK COVERS:
a. Blackout Drive Lamp Removal
c. Blackout Drive Light Housing Installation
b. Blackout Drive Light Housing Removal
d. Blackout Drive Lamp Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
MATERIALS/PARTS
TM 9-2320-260-20P
Two lockwashers
EQUIPMENT CONDITION
Four locknuts
• Parking brake set (TM 9-2320-260-10).
Three O-rings
• Battery ground cable disconnected (para. 4-48).
Gasket
I
a. Blackout Drive Lamp Removal
1. Remove three screws (14), lens cover (15), three O-rings
(13),
and gasket (12) from housing (1).
Discard O-rings
(13)
and gasket (12).
2.
Remove lamp (16) from housing (1).
b. Blackout Drive Light Housing Removal
NOTE
Tag all wires for installation.
1. Disconnect wire (3) from connector plug (2).
2. Remove nut (10), lockwasher (9), mounting washer (8), housing (1), and lockwasher (11) from
bracket (6). Discard lockwashers (9) and (11).
3. Remove four locknuts (7), screws (4), and mounting bracket (6) from headlight bracket (5). Discard
locknuts (7).
I
C
. Blackout Drive Light Housing Installation
1. Install mounting bracket (6) on headlight bracket (5) with four screws (4) and new locknuts (7).
2. Install housing (1) to mounting bracket (6) with new lockwasher (11), mounting washer (8), new
lockwasher (9), and nut (10).
3. Connect wire (3) to connector plug (2).
d. Blackout Drive Lamp Installation
1. Install lamp (16) in housing (1).
2. Install new gasket (12), three new O-rings (13), and lens cover (15) on housing (1) with three
screws (14).
4-74
Back to Top
