TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 523 of 1337
TM 9-2320-260-20
I
4-45. REAR COMPOSITE LIGHT HOUSING AND BRACKET REPLACEMENT
THIS TASK COVERS:
a. Removal (M818, M820, M820A1, M820A2)
g. Removal (M819)
b. Installation (M818, M820, M820A1, M820A2)
h. Installation (M819)
c. Removal (M817)
i.
Removal (M816)
d. Installation (M817)
j. Installation (M816)
e. Removal (M813, M813A1, M814)
k. Removal (M815)
f. Installation (M813, M813A1, M814)
l. Installation (M815)
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
MATERIALS/PARTS
TM 9-2320-260-20P
Twelve screw-assembled lockwashers
EQUIPMENT CONDITION
Eighteen lockwashers
• Parking brake set (TM 9-2320-260-10).
Thirteen locknuts
• Battery ground cable disconnected (para. 4-48).
NOTE
Tag all wires for installation.
a. Removal (M818, M820, M820A1, M820A2)
1.
Remove four screws (7) and cover (6) from bracket (11).
2. Disconnect four leads (12) from wires (10).
3. Remove two screw-assembled lockwashers (8) and housing (13) from bracket (11). Discard screw-
assembled lockwashers (8).
4. Remove locknut (16), screw (3), nut (9), screw (4), two lockwashers (5), and bracket (11) from
brace (2). Discard locknut (16) and lockwashers (5).
5. Remove two nuts (14), screws (15), and brace (2) from frame (1).
b. Installation (M818, M820, M820A1, M820A2)
1. Install brace (2) on frame (1) with two screws (15) and nuts (14).
2. Install bracket (11) on brace (2) with two new lockwashers (5), screw (4), nut (9), screw (3), and new
locknut (16).
3. Connect four leads (12) through hole in bracket (11) to wires (10).
4. Install housing (13) on bracket (11) with two new screw-assembled lockwashers (8).
5. Install cover (6) on bracket (11) with four screws (7).
4-82
Back to Top
