TM-9-2320-260-20

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

APRIL 1995

TM-9-2320-260-20 - Page 991 of 1337

TM 9-2320-260-20

13-8. FRONT WINCH REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

All W/W

MATERIALS/PARTS

Six locknuts

Fourteen lockwashers

EQUIPMENT CONDITION

•

Parking brake set (TM 9-2320-260-10).

• Winch cable, chain, and hook removed

(para. 13-5).

• Front winch propeller shaft removed (para. 13-9).

GENERAL SAFETY INSTRUCTIONS

REFERENCES (TM)

All personnel must stand clear during lifting

LO 9-2320-260-12

operations.

TM 9-2320-260-10

TM 9-2320-260-20P

1. Install chains around winch (2) and on lifting device.

2. Remove six locknuts (3), screws (7), and washers (8) from two support brackets (9) and mounting

brackets (4). Discard locknuts (3).

3. Remove six screws (1), lockwashers (11), and washers (10) from two mounting brackets (4) and rail

reinforcements (12). Discard lockwashers (11).

WARNING

All personnel must stand clear during lifting operations. A swing-

ing or shifting load may cause injury to personnel.

NOTE

Assistant will help with step 4.

4. Raise winch (2) and two mounting brackets (4) from vehicle, and lower winch (2) onto supports.

5. Remove chains from winch (2) and lifting device.

6. Remove eight screws (6), lockwashers (5), and two mounting brackets (4) from winch (2). Discard

lockwashers (5).

13-18