TM-9-2320-260-34-1

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 1 OF 2

JULY 1994

TM-9-2320-260-34-1 - Page 110 of 657

TM 9-2320-260-34-1

3-19. CAM FOLLOWER HOUSING MAINTENANCE (Contd)

f. Installation

1.

2.

3.

4.

5.

6.

CAUTION

• Ensure cam follower housing levers have been lubricated before

installation.

• If old cam follower housing assemblies are being installed,

ensure they are installed in the same location from which they

were removed.

NOTE

Check measurement of gasket previously removed. Thickness

must be the same as original gasket in the range of 0.014-0.125 in.

(0.36-3.2 mm).

Measure new gasket (3) thickness.

Position gasket (3) on cylinder block (1) with sealing surface facing outward.

Install cam follower housing (4) on cylinder block (1). Tap with soft-head hammer to seat on

dowels (2).

Install five new screw-assembled lockwashers (5) on cam follower housing (4). Finger tighten screw-

assembled lockwashers (5).

Install clamp (7) on cam follower housing (4) with new screw-assembled lockwasher (6). Tighten

screw-assembled lockwashers (5) and (6) 15 lb-ft (20 N•m) in sequence shown.

Tighten screw-assembled lockwashers (5) and (6) 30-35 lb-ft (41-48 N•m) in sequence shown.

3-58