TM-9-2320-260-34-2
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 2 OF 2
JULY 1994
TM-9-2320-260-34-2 - Page 629 of 863
TM 9-2320-260-34-2
Section IV. TRANSMISSION POWER TAKEOFF MAINTENANCE
16-39. TRANSMISSION POWER TAKEOFF MAINTENANCE INDEX
PARA.
NO.
TITLE
PAGE
NO.
16-40.
Transmission Power Takeoff Replacement
16-230
16-41.
Transmission Power Takeoff Repair
16-232
16-40. TRANSMISSION POWER TAKEOFF REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
All
TOOLS
General mechanic’s tool kit
(Appendix B, Item 1)
MATERIALS/PARTS
Seven lockwashers (Appendix D, Item 242)
Gasket (Appendix D, Item 134)
Locknut (Appendix D, Item 204)
Cotter pin (Appendix D, Item 48)
REFERENCES (TM)
LO 9-2320-260-12
TM 9-2320-260-20
TM 9-2320-260-34P-2
EQUIPMENT CONDITION
●
Front winch propeller shaft disconnected
(if so equipped) (TM 9-2320-260-20).
●
Hydraulic pump propeller shaft disconnected
(M817, M820A2) (TM 9-2320-260-20).
●
Front and rear cab tunnel covers removed
(TM 9-2320-260-20).
●
Transmission oil drained (LO 9-2320-260-12).
NOTE
Ž Perform step 1 for M817 and M820A2 vehicles.
●
Perform step 2 for vehicles except M817 and M820A2.
1.
Remove cotter pin (2), pin
(4),
and control rod (3) from PTO (1). Discard cotter pin (2).
2. Remove screw (7) and lockwasher (6) from PTO (1) and control lever (8). Discard lockwasher (6).
3. Remove locknut (5), screw (9), and control lever (8) from PTO (1). Discard locknut (5).
4.
Remove six nuts (12), lockwashers (11), PTO (1), and gasket
(13)
from transmission housing (14).
Discard lock washers (11) and gasket ( 13).
NOTE
Perform step 5 if studs are damaged.
5. Remove six studs (10) from transmission housing (14).
16-230
Back to Top
