TM-9-2320-260-34-2

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 2 OF 2

JULY 1994

TM-9-2320-260-34-2 - Page 775 of 863

17-26. THERMAL BARRIER INSULATION REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

lNITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-260-20

MATERIALS/PARTS

Adhesive (Appendix C, Item 2)

TM 9-2320-260-34P-2

EQUIPMENT CONDITION

●

Driver’s seat removed (TM 9-2320-260-20).

●

Companion seat removed (TM 9-2320-260-20).

NOTE

All thermal barrier insulation is replaced the same. This proce-

dure covers the left rear upper insulation panel only.

1. Pull panel (2) away from cab interior (1). Discard panel (2) if irreparable damage occurs when

removing.

2. Clean all remaining insulating material and adhesive from contact surface areas.

b. Installation

CAUTION

Once panel is coated with adhesive and put in place, it cannot be

moved. Be careful not to place panel in the wrong position.

NOTE

Make all necessary cutouts and slits in panels before installation,

Shiny side of panel must face outward.

1. Place panel (2) in cab interior (1) to check for fit.

2, Remove panel (2) and coat contact areas with adhesive.

3. Install panel (2) on cab (1) and press firmly into place.

17-74

TM 9-2320-260-34-2