c. Coolant Surge Tank.
WARNING
Extreme care should be taken when removing surge tank filler
cap if temperature gauge reads above 175°F (79°C). Steam or hot
coolant under pressure may cause injury.
(1)
Remove coolant surge tank filler cap (1). Visually check coolant level.
Surge tank (2) should be filled to approximately bottom end of filler tube (3) with
engine cold, and slightly above with engine at normal operating temperature.
NOTE
• Have suitable container ready to catch liquid contaminants.
• If surge tank on M939A2 series vehicles is found to be empty,
open drainvalve on aftercooler and fill surge tank. Close drain-
valve when coolant is observed flowing from drain, and continue
filling to approximately bottom end of fill tube.
(2)
If coolant level is low, add coolant as necessary.
(3)
Run engine until temperature gauge (4) reads 175°-200°F (79°-93°C).
Check and refill as necessary.
d. Power Steering Reservoir.
CAUTION
Do not overfill power steering reservoir. Oil will overflow into vent
system.
TM 9-2320-272-10
3-26
3-8. ENGINE SERVICE (Contd)