INSTALLATION
1.
Apply adhesive sealant to two insulators (Figure 3, Item 1) and install, as needed, on retaining straps
(Figure
3,
Item
22).
2.
Apply adhesive sealant to two rubber sheets (Figure 3, Item 16) and (Figure 3, Item 17) and install, as needed,
on hangers.
NOTE
Assistant will help with Step (2).
3.
Install fuel tank hangers (Figure 3, Item 14) on frame (Figure 3, Item 7) with eight screws (Figure 3, Item 18)
and locknuts (Figure 3, Item 2).
4.
Place wiring harness bracket (Figure 3, Item 5) over wiring harness and install lockwasher
(Figure
3,
Item
4), ground wire (Figure 3, Item 20), washer (Figure 3, Item 3), screw (Figure 3, Item 21),
washer (Figure 3, Item 3), lockwasher (Figure 3, Item 4), wiring harness bracket (Figure 3, Item 5), and locknut
(Figure 3, Item 6) on frame (Figure 3, Item 7).
5.
Install two support brackets (Figure 3, Item 10) on hangers (Figure 3, Item 14) with four screws
(Figure
3,
Item
11) and locknuts (Figure 3, Item 9).
6.
Install two fuel hanger stabilizing straps (Figure 3, Item 12) on hangers (Figure 3, Item 14) with eight screws
(Figure 3, Item 15) and locknuts (Figure 3, Item 13).
7.
Install two retaining straps (Figure 3, Item 22) and insulators (Figure 3, Item 1) on hangers (Figure 3, Item 14)
with two screws (Figure 3, Item 8) and locknuts (Figure 3, Item 19).
TM 9-2320-272-23-2
0253
0253-6