TM 9-2320-272-24-2
4-20. ROCKER LEVER HOUSING AND PUSH TUBES (M939/A1) MAINTENANCE (Contd)
2.
3.
4.
5.
6.
7.
8.
9.
Install three new gaskets (7) and rocker lever housings (6) on cylinder heads (8) and align push
tubes (9) with rocker levers.
Install upper radiator support bracket (1) and two lifting eyes (3) on rocker lever housings (6) with
six screws (2). Finger-tighten screws (2).
NOTE
Rocker lever housings are mounted using screw-assembled
lockwashers on late model engine.
Install twelve washers (5) and screws (4) on rocker lever housings (6) and cylinder heads (8).
Tighten screws (2) and (4) 50-65 lb-ft (68-88 N•m) in sequence shown.
Install three new gaskets (17) and rocker lever housing covers (18) on three rocker lever housings (6)
with fifteen screws (16). Tighten screws (16) 10-15 lb-ft (14-20 N•m).
Connect breather hose (20) to breather (19) with hose clamp (21).
NOTE
Perform step 7 for late model engine only.
Connect breather hose (23) to breather (19) and elbow (24) with two clamps (22).
NOTE
l
Perform steps 8 for no. three rocker lever housing cover only.
l
Assistant will help with step 8.
Turn left and right screw jacks (15) at the same time and lower cab on frame (11). Ensure clearance
between cab A-post (10) and jack screw (15) is 1-2 in. (25-50 mm).
Install two rubber cushions (12) on left and right cab A-posts (10) with two washers (13) and new
locknuts (14).
4-162