TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 344 of 951

TM 9-2320-280-20-2

4 - 1 0 6

Change 2

4 - 6 5 . DIRECTIONAL SIGNAL CONTROL REPLACEMENT

a. Removal

1.

Loosen connector nut (6) and remove connector plug (7) from directional signal control (4).

2.

Remove four screws (2) and directional signal control (4) from bracket (1).

INITIAL SETUP:

Applicable Models

M997A2, M1025A2, M1035A2, M1043A2,

M1045A2, M1097A2, M1123

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Manual References

TM 9-2320-280-10

TM 9-2320-280-24P

Equipment Condition

Battery ground cables disconnected (para. 4-73).

1.

Place lever (5) in HAZARD position.

2.

Install directional signal control (4) on bracket (1) with four screws (2). Do not tighten screws (2).

3 .

Rotate steering wheel ensuring pin (3) mates with directional signal control (4) and tighten screws (2)

to 22-26 lb-in. (2.5-2.9 N

•

m )

.

4.

Install connector plug (7) on directional signal control (4) and tighten connector nut (6).

b. Installation

This task covers:

a. Removal

b. Installation

FOLLOW-ON TASKS: • Connect battery ground cables (para. 4-73).

• Check directional signal control lamp for proper operation (TM 9-2320-280-10).