TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996
TM-9-2320-280-20-2

  TM-9-2320-280-20-2 - Page 426 of 951

Applicable Models
M996, M996A1, M997, M997A1, M997A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Four lockwashers (Appendix G, Item 136)
Plain-assembled nut (Appendix G, Item 201)
Lockwasher (Appendix G, Item 148)
Lockwasher (Appendix G, Item 141)
Lockwasher (Appendix G, Item 133)
Locknut (Appendix G, Item 128)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Battery ground cable disconnected
(para. 4-73).
TM 9-2320-280-20-2
4-188
Change 3
4-98. CONTROL BOX POWER CABLES REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
NOTE
Replacement of the control box power cables is basically the same
for M996, M996A1, M997, M997A1, and M997A2 vehicles.
1.
Remove four screws (6), lockwashers (5), and cover (7) from control box (1). Discard lockwashers (5).
2.
Remove nut (4) and ground cable (2) from ground stud (18).
3.
Remove locknut (12), lockwasher (13), washer (14), NBC harness cable (15), and positive cable (11)
from power stud (17). Discard lockwasher (13) and locknut (12).
4.
Remove plain-assembled nut (9), two clamps (10), power harness (8), and NBC harness (22)
from
screw (16). Discard plain-assembled nut (9).
NOTE
Step 5 is for M997, M997A1, and M997A2 vehicles only.
5.
Remove two screws (20) two clamps (19) and power harness (8) from body (21) and remove
clamps (19) from harness (8).
NOTE
Steps 6 thru 8 apply to M996 and M996A1 vehicles only.
6.
Remove four screws (20), five clamps (19), and power harness (8) from body (21). Remove
clamps (19) from harness (8).
a. Removal


Back to Top