TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996

TM-9-2320-280-20-2 - Page 842 of 951

TM 9-2320-280-20-2

8-11. REAR WHEEL TOE-OUT ALIGNMENT (Cont’d)

c. Toe-out Adjustment

1.

Loosen two locknuts (1) securing two clamps (3) on each adjusting sleeve (2).

NOTE

Toe-out can be increased or decreased by changing length of

radius rods. A threaded sleeve is provided for this purpose.

2.

Turn each adjusting sleeve (2) equally but in opposite directions.

3.

Roll vehicle rearward then forward to original position.

4.

Repeat toe-out check and adjustment procedures until correct adjustment is indicated.

5.

Secure two clamps (3) on each adjusting sleeve (2) with two locknuts (1). Tighten locknuts (1).

to 30 lb-ft (40 N m).

FOLLOW-ON TASK: Operate vehicle (TM 9-2320-280-10) and check for pull or wander.

8-42