TM-9-2320-280-20-3
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3
JANUARY 1996
TM-9-2320-280-20-3 - Page 342 of 1168
11-67. TOW WIRING HARNESS REPLACEMENT
This task covers:
a. Removal
b.
Installation
a. Removal
1.
Uncoil TOW wiring harness (9) and MGS power cable (7) from cable stowage cleat (10).
2.
Remove plain-assembled nut (3) and clamp (2) from TOW wiring harness (9), MGS power cable (7),
and support assembly (4). Discard plain-assembled nut (3).
3.
Remove two plain-assembled nuts (6), screws (1), and clamps (5) from TOW wiring
harness (9), MGS power cable (7), and “B” pillar (8). Discard plain-assembled nuts (6).
4.
Uncoil TOW wiring harness (9) and MGS power cable (7) from cable stowage cleat (10).
5.
Disconnect VPC cable (11) from connector receptacle (12).
6.
Remove four plain-assembled nuts (13), screws (16), cover (15), and connector receptacle (12) from
bracket (14). Discard plain-assembled nuts (13).
7.
Remove two plain-assembled nuts (17), screws (19), and clamps (18) from TOW wiring harness (9)
and battery box (20). Discard plain-assembled nuts (17).
NOTE
Perform steps 1 through 3 for vehicles with serial numbers 99,999
and below and step 4 for vehicles with serial numbers 100,000 and
above.
INITIAL SETUP:
Applicable Models
M966, M966A1, M1036, M1045, M1045A1,
M1045A2, M1046, M1046A1
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Grease (Appendix C, Item 24)
Two lockwashers (Appendix G, Item 133)
Eight plain-assembled nuts (Appendix G, Item 201)
Lockwasher (Appendix G, Item 148)
Lockwasher (Appendix G, Item 141)
Four plain-assembled nuts (Appendix G, Item 202)
Manual References
TM 43-0139
TM 9-2320-280-24P
Equipment Condition
Battery ground cable disconnected (para. 4-73).
TM 9-2320-280-20-3
11-92
Change 2
Back to Top
