TM-9-2320-280-20-3

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3

JANUARY 1996
TM-9-2320-280-20-3

  TM-9-2320-280-20-3 - Page 44 of 1168

10-17. ENGINE LEFT SPLASH SHIELD MAINTENANCE
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Seven locknuts (Appendix G, Item 107)
Four lockwashers (Appendix G, Item 143)
Assembled locknut (Appendix G, Item 131)
Three locknuts (Appendix G, Item 79)
Two locknuts (Appendix G, Item 70)
Locknut (Appendix G, Item 128)
Lockwasher (Appendix G, Item 134)
Four rivets (Appendix G, Item 239)
Manual References
TM 9-2320-280-24P
Equipment Condition
• Battery ground cable disconnected
(para. 4-73).
• Hood prop rod and bracket removed
(para. 10-4).
General Safety Instructions
Hood must be supported during removal and
installation.
WARNING
Hood must be supported during removal and installation. Failure
to support hood may cause injury to personnel and damage to
equipment.
NOTE
• Left splash shield maintenance is the same for all vehicles, except
M998, M998A1, M1035, M1035A1, M1035A2, M1037, M1038,
M1038A1, and M1042 vehicles do not have an armor plate
attached to side of shield.
• The left splash shield can be modified with an access cover
which will provide easier access to transmission oil cooler lines, at
commander’s discretion. Refer to appendix D, Figs. D-86 and D-87.
1.
Disconnect hood harness (27) from connector receptacle (30).
2.
Remove locknut (3), washer (2), capscrew (24), and washer (2) from splash shield (15) and
support bracket (1). Discard locknut (3).
3.
Remove locknut (10), washer (11), washer (12), capscrew (20), and washer (11) from splash
shield (15) and airlift bracket (9). Discard locknut (10).
4.
Remove capscrew (21), lockwasher (22), and washer (23) from splash shield (15) and airlift
bracket (9). Discard lockwasher (22).
5.
Remove four screws (28) , lockwashers (29), and connector receptacle (30) from bracket (32).
Discard lockwashers (29).
6.
Remove assembled locknut (39) and screw (37) from harness and clamp (38) and
splash shield (15).Discard assembled locknut (39).
7.
Remove locknut (13), washer (14), capscrew (19), washer (14), and splash shield (15) from
bracket (16). Discard locknut (13).
NOTE
Perform step 1 only if vehicle has an armor plate.
1.
Remove locknut (33), washer (34), capscrew (36), washer (34), and armor plate (35) from splash
shield (15). Discard locknut (31).
b. Disassembly
a. Removal
TM 9-2320-280-20-3
10-28
Change 2


Back to Top