TM-9-2320-280-20-3
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3
JANUARY 1996
TM-9-2320-280-20-3 - Page 46 of 1168
10-17. ENGINE LEFT SPLASH SHIELD MAINTENANCE (Cont'd)
1.
Install bushing (17) on splash shield (15) with four rivets (18).
2.
Install bracket (32) on splash shield (15) with two washers (26), capscrews (31),
washers (26), and locknuts (25). Tighten locknuts (25) to 6 lb-ft (8 N
•
m).
3.
Install seal (5) and seal retainers (4) on splash shield (15) with seven capscrews (6), washers (7),
and locknuts (8).
NOTE
Perform step 4 only if vehicle has an armor plate.
4.
Install armor plate (35) on splash shield (15) with washer (34), capscrew (36),
washer (34), and locknut (33). Tighten locknut (33) to 15 lb-ft (20 N
•
m).
1.
Install splash shield (15) on bracket (16) with washer (14), capscrew (19), washer (14), and
locknut (13).
2.
Install harness and clamp (38) on splash shield (15) with screw (37) and assembled locknut (39).
3.
Install connector receptacle (30) on bracket (32) with four lockwashers (29) and
screws (28).
4.
Install splash shield (15) to airlift bracket (9) with washer (23), lockwasher (22), and capscrew (21).
Tighten capscrew (21) to 10 lb-ft (14 N
•
m).
5.
Install splash shield (15) on airlift bracket (9) with washer (11), capscrew (20), washer (12),
washer (11), and locknut (10). Tighten capscrew (20) to 10 lb-ft (14 N
•
m).
6.
Install splash shield (15) on support bracket (1) with washer (2), capscrew (24), washer (2), and
locknut (3). Tighten capscrew (24) to 6 lb-ft (8 N
•
m).
7.
Connect hood harness (27) to connector receptacle (30).
d. Installation
c. Assembly
TM 9-2320-280-20-3
10-30
Change 2
Back to Top
