TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 148 of 1258

TM 9-2320-280-34

3-23. ENGINE INSTALLATION (6.2 L) (Cont'd)

12.

Install leads 74A (3) and 74B (5) on solenoid (2) with clip (6) and screw (7).

NOTE

Steps 13 through 16 apply to vehicle M1026, M1036, M1038, M1042,

M1044, and M1046 only.

Proceed to step 17 for all other vehicle

models.

13.

Install positive cable 6A (17), lead 81A (4), lead 81B (8), and lead 6 (22) on starter terminal (23) with

lockwasher (10) and nut (9).

Using torque adapter, tighten nut (9) to 25 lb-ft (34 N m).

14.

Install negative cable 7A (16), lead 3D (13), and lead 7 (25) on starter terminal (24) with

lockwasher (12) and nut (11).

Using torque adapter, tighten nut (11) to 15 lb-ft (20 N m).

15.

Install two clamps (14), positive cable 6A (17), and negative cable 7A (16) on starter (1) with screw

(15).

16.

Install clamp (21) and leads 6 (22) and 7 (25) on oil pan bracket (19) with capscrew (20) and nut and

lockwasher assembly (18).

17.

Connect positive cable 6A (17), lead 81A (4), and lead 81B (8) to starter (1) with lockwasher (10)

and nut (9).

18.

Connect negative cable 7A (16) and lead 3D (13) to starter (1) with lockwasher (12) and nut (11).

19.

Install two clamps (14), positive cable 6A (17), and negative cable 7A (16) on starter (1) with screw

(15).

20.

Using torque adapter, tighten nut (11) to 15-lb-ft (20 N m) and nut (9) to 25 lb-ft (34 N m).

3-86