TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 160 of 1258

TM 9-2320-280-34

3 - 23.

ENGINE INSTALLATION (6.2L) (Cont ’d)

NOTE

Installation for the 100 amp and 200 amp Neihoff regulators

are basically the same.

Differences are shown in the

illustration.

91.

Apply sealing compound to threads of capscrew (10).

92.

Install spacer (14) and voltage regulator (12) on alternator (15) with lockwasher (11) and capscrew (10).

Tighten capscrew (10) to 88-94 lb-in. (10-11 N m).

93.

Install two washers (16), lockwashers (17) and screws (18) on voltage regulator (12) and

alternator (15).

Tighten screws (18) to 30-34 lb-in (3-4 N m).

94.

Install washer (1), lead 5A (2), and nut (3) on red (energize) terminal (19).

Tighten nut (3) to

23-27 lb-in. (2.6-3.0 N m). Slide rubber boot (4) over terminal (19).

95.

Install washer (8), lead 2A (7), and nut (6) on yellow (AC) terminal (9).

T

ighten nut (6) to 18-22 lb-in.

(2.0-2.5 N m). Slide rubber boot (5) over terminal (9).

96.

Connect regulator plug (13) to voltage regulator (12).

3-98