TM-9-2320-280-34

TM-9-2320-280-34 - Page 25 of 1258

TM 9-2320-280-34

CHAPTER 2

GENERAL MAINTENANCE

Section I. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT

AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT

2-1. COMMON TOOLS AND EQUIPMENT

Refer to Modified Table of Organization and Equipment (MTOE) for authorized common tools and

equipment applicable to your unit.

2-2. SPECIAL TOOLS AND SUPPORT EQUIPMENT

Special tools and support equipment are listed and illustrated in TM 9-2320-280-24P.

2-3. TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE)

Calibrate all measuring and test equipment used to determine equipment conformance in accordance with

TB 43-1800.

2-4. FABRICATED TOOLS

Fabricated tools needed to maintain the equipment in this manual can be found in appendix C. These tools

are not available for issue, but must be fabricated and applied by direct and general support personnel only.

2-5. REPAIR PARTS

Repair parts are listed and illustrated in TM 9-2320-280-24P, except for engine assembly repair parts which

are listed and illustrated in TM 9-2815-237-34P.

Pre-1990 and 1990 and above 6.2 L and 6.5 L engines have some new and revised parts which are not

interchangeable. These part changes affect some of the maintenance procedures in chapters 3 and 4. Refer

to engine decal on left rocker arm cover before performing maintenance procedures and ordering

replacement parts.

The 6.2 L engine is identified by a decal which is adhered to the left rocker arm cover. The 6.5 L engine is

identified by a serial number bar code.

2-1