6 - 7 . STE/ICE-R WIRING HARNESS REPLACEMENT
This task covers:
a.
Removal
b.
Installation
NOTE
• Prior to removal tag leads for installation.
• Refer to TM 9-2320-280-20 for repair of wiring harness
connections.
1.
Remove two screws (4), lockwashers (5), and STE/ICE-R harness leads 7B-7D (6), 8A (1),
and 9A (7) from shunt (8). Discard lockwashers (5).
2.
Remove boot (9) from power stud (11). Remove nut (29) and lockwasher (30) from leads 6B-6C (12)
and 6A (10) and power stud (11), and disconnect lead 6B-6C (12). Discard lockwasher (30).
3.
Remove nut (27) and lockwasher (28) from leads 3D (23) and 7A (26) on starter (18) and disconnect
lead 3D (23). Discard lockwasher (28).
4.
Remove nut (22) and lockwasher (21) from leads 6A (10), 81A (19), and 81B (20) on starter (18) and
disconnect lead 81B (20). Discard lockwasher (21).
5.
Remove screw (13) and retainer (14) from leads 74A (16) and 74B (15) on starter solenoid (17) and
disconnect lead 74B (15).
6.
Remove screw (25) and clamp (24) from leads 3D (23), 6A (10), 74B (15), and 81B (20) on
starter (18).
CAUTION
Use care when removing harness. Snagging or pulling may cause
damage to harness.
7.
Remove harness (32) and grommet (2) from battery compartment (3).
8.
Slide harness (32) out of protective shield (31).
INITIAL SETUP:
To o l s
____
General mechanic's tool kit:
automotive (Appendix G, Item 1)
Special To o l s
__________
Torque adapter, 3/4 in. (Appendix G, Item 107)
M a t e r i a l s / P a rt s
_____________
Six lockwashers (Appendix E, Item 69)
Four nut and lockwasher assemblies
(Appendix E, Item 94)
Antiseize compound (Appendix B, Item 7)
Manual Refere n c e s
________________
TM 9-2320-280-20
TM 9-2320-280-24P
Equipment Condition
_________________
• Battery holddown removed (TM 9-2320-280-20).
• Engine access cover removed (TM 9±-±2±3±2±0±-±2±8±0±-±2±0±)±
.
Maintenance Level
_______________
Direct support
TM 9-2320-280-34
6 - 6 2
Change 1
a. Removal