TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996
TM-9-2320-280-34

  TM-9-2320-280-34 - Page 411 of 1258

6-7. STE/ICE-R WIRING HARNESS REPLACEMENT (Cont'd)
9.
Remove three screws (2) and clamps (16) from harness (9) and body (1).
10.
Remove two screws (10) and clamps (12) from body harness (11), harness (9) and body (1).
11.
Disconnect harness connector (18) from rpm sensor connector (22).
12.
Disconnect harness connector (8) from fuel pressure transducer connector (7).
13.
Remove nut (20), lockwasher (21), and clamp (19) from harness (9) and transmission (17). Discard
lockwasher (21).
14.
Remove cover (5) from STE/ICE-R DCA assembly (6).
15.
Remove screw (4), washer (14), nut and lockwasher assembly (13), harness ground 7C (15), and
cover retainer (3) from body (1) and assembly (6). Discard nut and lockwasher assembly (13).
16.
Remove remaining three screws (4), washers (14), nut and lockwasher assemblies (13) from DCA
assembly (6) and body (1). Discard nut and lockwasher assemblies (13).
17.
Remove DCA assembly (6) and harness (9).
NOTE
Refer to TM 9-2320-280-20 for repair of wiring harness connectors.
1.
Install STE/ICE-R harness (9) on body (1) in approximate mounting location.
CAUTION
Use care when routing harness. Snagging or pulling may cause
damage to harness.
2.
Connect harness connector (8) to fuel pressure transducer connector (7).
3.
Connect harness connector (18) to rpm sensor connector (22).
4.
Install harness (9) on transmission (17) with clamp (19), lockwasher (21), and nut (20).
5.
Install harness (9) and body harness (11) on body (1) with two clamps (12) and screws (10).
Finger tighten screws (10).
6.
Install DCA assembly (6) on body (1) with three screws (4), washers (14), and nut and
lockwasher assemblies (13).
7.
Apply antiseize compound to harness ground 7C (15). Install cover retainer (3) and harness
ground 7C (15) on body (1) and assembly (6) with screw (4), washer (14), and nut and lockwasher
assembly (13).
8.
Install cover (5) on DCA assembly (6).
9.
Install harness (9) on body (1) with three clamps (16) and screws (2). Finger tighten screws (2).
b. Installation
TM 9-2320-280-34
6 - 6 4
Change 1


Back to Top