TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996

TM-9-2320-280-34 - Page 733 of 1258

TM 9-2320-280-34

14 - 27 .

AIR CONDITIONING COMPRESSOR REPAIR (Cont ’d)

14.

Install field coil (13) onto seal housing (4), making sure bump on field coil (13) fits in locating

depression on compressor housing (14). Using snapring pliers, install snapring (12) on seal

housing (4) to secure field coil (13).

15.

Install field coil lead wires (15) on compressor housing (14) with clip (9) and screw (8).

CAUTION

Do not clamp compressor body in vise. Clamp or support only at

mounting ears, with blocks of wood, to prevent damage to

compressor body.

16.

Clamp compressor housing (14) in vise with blocks of wood on mounting ears.

17.

Place rotor pulley (10) on seal housing (4), making sure it is not misaligned or crooked.

18.

Place rotor pulley installer into bearing cavity of rotor pulley (10), making sure the outer edge of the

installer rests on the bearing outer race (11).

CAUTION

Make sure all slack is taken out of field coil lead wires (with clamp)

before installing rotor pulley to prevent damage to lead wires.

19.

Place driver on rotor pulley installer, and tap driver with hammer until rotor pulley (10) fully seats

on seal housing (4).

14-133