TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 736 of 1258
TM 9-2320-280-34
14 - 28.
AMBULANCE WINDSHIELD REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Applicable Models
Manual References
M996, M996A1, M997, M997A1, M997A2
TM 9-2320-280-20
TM 9-2320-280-24P
Tools
General mechanic's tool kit:
Equipment Condition
automotive (Appendix G, Item 1)
Windshield wiper arm pivots removed
(TM 9-2320-280-20).
Materials/Parts
Wood block, 4 in. x 4 in., 40 in. (1016 mm) long
General Safety Instructions
Wood block, 4 in. x 4 in., 24 in. (610 mm) long
Do not perform this procedure near fire, flames, or
Twelve rivets (Appendix E, Item 140)
sparks.
Personnel Required
Maintenance Level
One mechanic
Direct support
One assistant
a. Removal
1.
Remove six capscrews (1) and washers (2) from two rear windshield mounting brackets (5) and
windshield (4). Remove shims (3) from behind mounting brackets (5), if present.
2.
Remove three screws (7), clamps (6), antenna cables (8), and intercom cable (9) from windshield (4).
3.
Remove three hitch pins (10) and windshield hinge pins (12) from front hinges (11) and lower
hinges (13).
NOTE
·
Perform steps 4, 5, and 7 for M996 and M996A1 vehicles only.
·
Have drainage container ready to catch fuel.
4.
Close heater fuel shutoff valve (14) at heater fuel line (15).
WARNING
Diesel fuel is highly flammable. Do not perform this procedure near
fire, flames, or sparks. Severe injury or death will result.
5.
Disconnect heater fuel line (15) above shutoff valve (14).
6.
Remove two capscrews (17) and washers (16) from front of ambulance body (18) and cargo
floor (19).
14-136
Back to Top
